BHD Eliminators and Components 250 Spine
BHD Eliminator SD Arrow Shafts 250-300-350-400 spines available with halfserts and Sleeves or 90grn halfsert and Stainless Sleeve
Are you looking for a hand selected and tested shaft that meets its description?
The BHD Eliminator is tested and selected in house, not just factory selected.
By doing this I can guarantee spine deflection and straightness and therefore provide you a consistent and closely matched batch of shafts per dozen.
• .003 straightness or better guaranteed ( all shafts are hand selected by myself )
•+\- 2gn & .007 spine deflection difference
• .204 ID & .274 OD
•12x half Outsert and Stainless Steel Half serts and Sleeves
•X Nock installed
•Installation meathod : square off arrow carbon. Clean halfsert and inside carbon shaft. Glue in halfsert let set. Clean down excessive glue from between halfsert and carbon shaft and make sure sleeve slides over nicely, can sand carbon and half sert to make round and clean away residual glue. Test fit sleeve and spin. No need to glue On sleeve broadhead or field point will hold it in place. Doing this will make it easier to change a damaged sleeve if you need to.